Short answer: Yes. Environment and Climate Change Canada says cold climate heat pumps work in temperatures as low as -30°C. A heat pump still absorbs less heat as the air gets colder, though, and NRCan says most air-source models have a minimum operating temperature. So ask what your exact model delivers at your coldest temperature.
What happens to a heat pump as it gets colder?
NRCan says cold air still holds a lot of heat: the heat in air at -18°C is 85% of the heat in air at 21°C. So a heat pump can keep heating on a cold January morning, but it has more work to do, because NRCan says its ability to absorb heat drops as the outdoor temperature drops.
NRCan says the coefficient of performance (COP) of air-source heat pumps typically ranges from 2.0 to 5.4 at 8°C and from 1.1 to 3.7 at -8°C. Even a COP of 1.1 delivers more heat than the electricity it uses, but the range is wide, so your model's own figures matter. Three temperatures shape how much of your winter the heat pump covers on its own.
You may qualify for up to $10,000 back
Tap through a few questions and see your rebate in 2 minutes. No email.
Check my eligibility
What are the balance point and cut-off temperature?
NRCan says the thermal balance point is the outdoor temperature below which the heat pump can't meet your home's heating needs on its own. The economic balance point is the temperature below which the backup system is cheaper to run than the heat pump. The cut-off temperature is the heat pump's minimum operating temperature.
NRCan says most air-source systems shut off at one of these three temperatures, and your installation contractor can set it. Ask which one yours uses, because below it only the supplementary system runs.
How cold is too cold for a heat pump?
It depends on the model, and the official figures don't line up exactly. Environment and Climate Change Canada says cold climate heat pumps work in temperatures as low as -30°C. NRCan's heat pump guide says the vast majority of air-source heat pumps have a minimum operating temperature, which for newer models ranges from -15°C to -25°C, and that a supplemental system must provide the heat below it.
Pro tip before you buy: ask each contractor for the heating output at your coldest temperature and the minimum operating temperature of your exact model, taken from the manufacturer's data. Environment and Climate Change Canada says exact performance depends on where you live and the heating system you're switching from, so a general figure won't tell you.
What backup heat will you need?
NRCan says most air-source installations need a supplementary heat source on the coldest days, and sometimes while the unit defrosts. An all electric setup adds electric resistance elements in the ductwork or electric baseboards, which are less efficient than the heat pump but don't depend on the outdoor temperature. A hybrid setup pairs the heat pump with a furnace or boiler, and NRCan calls it a good option when a heat pump is added to an existing system.
If you use electric backup, NRCan recommends setting its thermostat 2°C to 3°C below the heat pump's set-point so the heat pump does more of the heating. Those choices come down to a few questions for your contractor.
What should you ask your contractor?
Ask each contractor these five questions:
- "What heating capacity does this exact unit have at my coldest temperature, from the manufacturer's data?"
- "What is its minimum operating temperature?"
- "Where are the thermal and economic balance points for my home?"
- "What backup heat is included, and what will it cost to run on the coldest days?"
- "Does it have demand-defrost control?"
NRCan says unnecessary defrost cycles reduce a heat pump's seasonal performance, and demand-defrost control starts a cycle only when it's needed. Environment and Climate Change Canada says improper sizing or installation can reduce efficiency, and NRCan says an undersized unit leans on its backup more often, so ask how your contractor is making sure yours is properly sized.
Does the rebate cover a cold climate heat pump?
Canada.ca says the National Heat Pump Rebate supports households installing a cold climate heat pump. The unit has to be on the eligible product list, identified by its AHRI number, so check yours on our eligible heat pump list. Canada.ca says households above median income may be eligible for $2,000 and households below median income for up to $10,000. Installs from November 1, 2026 may qualify, and the portal opens in early 2027. Our page on who qualifies covers the rules, and installing now or waiting covers the timing.
Frequently asked questions

NRCan says most air-source installations need a supplementary heat source on the coldest days. Ask your contractor where the balance point is for your house.
Yes. NRCan says the typical COP of air-source heat pumps falls from 2.0 to 5.4 at 8°C to 1.1 to 3.7 at -8°C. A COP above 1 still means the system delivers more heat than the electricity it uses.
The bottom line
Heat pumps work in Canadian winters when the model suits your home: Environment and Climate Change Canada says cold climate models work as low as -30°C, and NRCan gives -15°C to -25°C as the minimum for newer air-source models. The rebate is $2,000 above median income or up to $10,000 below it.
Your next step is to check whether your household could get the rebate before you collect quotes. Then our vetted, licensed contractors can quote the exact model and put its AHRI number in writing.
Sources: NRCan, heating and cooling with a heat pump · Environment and Climate Change Canada, find the facts about electric heat pumps · Environment and Climate Change Canada, heat pump basics · Canada.ca, National Heat Pump Rebate
Written and reviewed by 
